Differences

This shows you the differences between two versions of the page.

--- mdcpickandplace:diytray [2010/10/12 01:02]
ladyada
+++ mdcpickandplace:diytray [2010/10/12 01:20]
ladyada
@@ Line 1: / Line 1: @@
-<iframe src="http://player.vimeo.com/video/15752459" width="400" height="225" frameborder="0"></iframe><p><a href="http://vimeo.com/15752459">This old pick and place - making a tray</a> from <a href="http://vimeo.com/adafruit">adafruit industries</a> on <a href="http://vimeo.com">Vimeo</a>.</p>
+{{ vimeo>15752459 }}
 ----
@@ Line 15: / Line 14: @@
 Total is $50
+====== Quick instructions ======
+Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer.
+Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer. Keep the left side loose for later adjustment
+Cut two rails from 1/16" material with 5mm drill holes so that the top edge doesnt rise above the JEDEC tray thickness
+Attach the rails with T-slot nuts.
+Place the tray on the holder, slide the left side in and tighten.

AdaWiki