mdcpickandplace:diytray
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
mdcpickandplace:diytray [2010/10/12 01:05] ladyada |
mdcpickandplace:diytray [2010/10/12 01:20] ladyada |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer. | Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer. | ||
| - | Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer. | + | Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer. Keep the left side loose for later adjustment |
| + | Cut two rails from 1/16" material with 5mm drill holes so that the top edge doesnt rise above the JEDEC tray thickness | ||
| + | |||
| + | Attach the rails with T-slot nuts. | ||
| + | |||
| + | Place the tray on the holder, slide the left side in and tighten. | ||
/home/ladyada/public_html/wiki/data/pages/mdcpickandplace/diytray.txt · Last modified: 2016/01/28 18:05 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
