pcbchecklist
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
pcbchecklist [2010/02/10 19:11] ladyada created |
pcbchecklist [2016/01/28 18:05] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - Run an ERC | - Run an ERC | ||
| - | - Run a DRC | + | - Run a DRC |
| - Check stop mask - do you want tenting? | - Check stop mask - do you want tenting? | ||
| - Sometimes its cheaper to have both sides masked the same so mirror any stop masks like 'heat sink' planes onto the other side | - Sometimes its cheaper to have both sides masked the same so mirror any stop masks like 'heat sink' planes onto the other side | ||
| - Check the layout with Gerbv or another gerber viewer | - Check the layout with Gerbv or another gerber viewer | ||
| - | * are the bottom and top lined up? | + | * are the bottom and top lined up? |
| - | * Are the holes in the right place? | + | * Are the holes in the right place? |
| - | * silkscreen looking good, nothing overlapping? | + | * silkscreen looking good, nothing overlapping? |
| - | * bottom/top components there? | + | * bottom/top components there? |
| - | - (optional) Sometimes its cheaper to have fewer drills, so edit the drill file to keep the | + | - (optional) Sometimes its cheaper to have fewer drills, so edit the drill file to keep the tool number low (sometimes your CAD program can do this too) |
| - | tool number low (sometimes your CAD program can do this too) | + | |
| - Do you need scoring? | - Do you need scoring? | ||
| - Do you need panelizing? If so, scored or tab-route? | - Do you need panelizing? If so, scored or tab-route? | ||
| + | - If you panelize, make sure to send your solderpaste layer for them to tile at the same time | ||
| - Do you need lead free? | - Do you need lead free? | ||
| + | - Did you stick some fiducials in there? | ||
| + | - What color mask and silk? For me, blue and white. | ||
| + | - What finish? I like Gold Immersion | ||
| + | - For panelization, 3mm holes in the corners will work best with an STP-350 printer | ||
/home/ladyada/public_html/wiki/data/attic/pcbchecklist.1265829101.txt.gz · Last modified: 2016/01/28 18:05 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
