skip to content

AdaWiki

User Tools

Log In

Site Tools

Recent Changes
Media Manager
Sitemap

You are here: start » smt

Trace:

smt

====== Stencil notes ======

Stencil thickness makes a difference! Thicker stencils allow more paste to be deposited which is good for large parts and connectors but can cause shorts with finer pitch parts. 

To calculate the optimal stencil thickness for fine pitch placement, IPC standard #7525 states:

> Stencil Thickness = 2.64 + 0.0831 * Pitch of component (in mils)

So, say for an FT232RL chip, which is a SSOP part with 0.65mm pitch. First figure out the pitch in thousands of an inch:

> 0.65 mm / 25.4 = 0.0256 inches = 25.6 mils

Then calculate according to the equation above

> 2.64 + 0.0831 * 25.6 = 2.13 + 2.64 = 4.77 mil 

So for SSOP parts, 4 to 5 mil is the thickest you should go

/home/ladyada/public_html/wiki/data/attic/smt.1283912999.txt.gz · Last modified: 2016/01/28 18:05 (external edit)

Page Tools

Show page
Old revisions
Backlinks
Back to top

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

CC Attribution-Share Alike 4.0 International