tutorials:products:bonebox
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tutorials:products:bonebox [2012/01/28 08:00] pburgess [Assembly] |
tutorials:products:bonebox [2012/03/08 21:20] pburgess [Assembly] |
||
|---|---|---|---|
| Line 42: | Line 42: | ||
| {{ :tutorials:products:bonebox:dexterity.jpg?nolink& |}} | {{ :tutorials:products:bonebox:dexterity.jpg?nolink& |}} | ||
| - | * Slide a nylon spacer over each of the four screws. | + | * Slide a nylon spacer over each of the four screws. **VERY IMPORTANT: Use ONLY the standoffs included with the kit. DO NOT use wider standoffs in their place, and SUPER ESPECIALLY DO NOT use nuts as a makeshift standoff. The component clearances on the BeagleBone are //very// close, and using the wrong standoffs could result in components being sheared off the board!** |
| * Slide the base plate over the screws, coming to rest on the spacers. There's a specific orientation for the base plate: one of the four alignment studs is smaller than the others — this should be positioned closest to the USB client port. | * Slide the base plate over the screws, coming to rest on the spacers. There's a specific orientation for the base plate: one of the four alignment studs is smaller than the others — this should be positioned closest to the USB client port. | ||
| * Install four nuts and gently tighten each screw. | * Install four nuts and gently tighten each screw. | ||
| Line 79: | Line 79: | ||
| * Press the front face flush again and tighten all the screws. Acrylic is brittle, so don't crank these down too hard – finger pressure plus 1/8 turn is sufficient. Insert the microSD card (make sure it goes into the card slot, NOT loose in the case!). Bingo…you're done! | * Press the front face flush again and tighten all the screws. Acrylic is brittle, so don't crank these down too hard – finger pressure plus 1/8 turn is sufficient. Insert the microSD card (make sure it goes into the card slot, NOT loose in the case!). Bingo…you're done! | ||
| + | |||
| + | ====== Access ====== | ||
| To access the board or cape later, it's not necessary to rewind this entire process — most of the parts can be left in place! Just loosen the front case screws 1/8", tip the front face back and pivot the case upward: | To access the board or cape later, it's not necessary to rewind this entire process — most of the parts can be left in place! Just loosen the front case screws 1/8", tip the front face back and pivot the case upward: | ||
| {{ :tutorials:products:bonebox:fliptop.jpg?nolink& |}} | {{ :tutorials:products:bonebox:fliptop.jpg?nolink& |}} | ||
/home/ladyada/public_html/wiki/data/pages/tutorials/products/bonebox.txt · Last modified: 2016/01/28 18:05 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
