User Tools

Site Tools


x0x:midisyncmods

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

x0x:midisyncmods [2016/01/28 18:05]
x0x:midisyncmods [2016/01/28 18:05] (current)
Line 1: Line 1:
 +===== IO Board Mods =====
 +
 +Because of the relative simplicity of this section, there isn't much in the way of mods to be done here.
 +
 +
 +
 +==== Change Midi Out to Another Midi Thru ====
 +<note warning> **VerifyMe:​** Someone competent with electronics needs to look over this to make sure it is correct. </​note>​
 +Cut the trace to pin 5, and wire it up a 220 Ohm resistor to the Collector of Q50
 +
 +Alternatively,​ this could be done in the FirmWare
 +
 +==== Double Duty for the Jacks ====
 +
 +The ring of Mix In and Mix Out are disconnected,​ and can be used as inputs (or outputs) for some of the VcoMods, VcfMods, EnvelopeMods or VcaMods.  ​
 +
 +The headphone out is split at the IO Board with the two resistors R164 and R186.  You could disconnect one of them to also make it double as an input or an output.
 +
 +
 +{{template>​.templates:​fabmenu}}
 +
 +CategoryMods
  
/home/ladyada/public_html/wiki/data/pages/x0x/midisyncmods.txt · Last modified: 2016/01/28 18:05 (external edit)