Differences

This shows you the differences between two versions of the page.

--- mdcpickandplace:download [2009/11/03 02:50]
ladyada created
+++ mdcpickandplace:download [2009/11/03 03:07]
ladyada
@@ Line 1: / Line 1: @@
 Our MDC showed up with loose "homing dots" - the brackets on either side of the bank 1 feeders. As such the machine was not calibrated, and we needed to change the "Mark Calibration", here are Isono's instructions: {{:mdcpickandplace:mdc_luna_mark_adjustment.pdf|}}
-The manual for the software for the Luna EXP that we grabbed from the MDC website - we have the EXP NX but if you're in a bind, this is pretty damn close:  {{:mdcpickandplace:lunaexpmanuale.pdf|}}
+===== Manuals =====
+The manual for the software for the Luna EXP NX: {{:mdcpickandplace:lunaexpnxmanuale.pdf|}}
+The manual for the software for the Luna EXP:  {{:mdcpickandplace:lunaexpmanuale.pdf|}}
+===== Spec & Data sheets =====
 The spec sheet for the MDC Luna EXP NX (stepper motors) {{:mdcpickandplace:lunaexpnxe.pdf|}}

AdaWiki