This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
mdcpickandplace:download [2009/11/03 02:50] ladyada created |
mdcpickandplace:download [2016/01/28 18:05] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | Our MDC showed up with loose "homing dots" - the brackets on either side of the bank 1 feeders. As such the machine was not calibrated, and we needed to change the "Mark Calibration", here are Isono's instructions: {{:mdcpickandplace:mdc_luna_mark_adjustment.pdf|}} | + | ===== Manuals ===== |
- | The manual for the software for the Luna EXP that we grabbed from the MDC website - we have the EXP NX but if you're in a bind, this is pretty damn close: {{:mdcpickandplace:lunaexpmanuale.pdf|}} | + | The manual for the software for the Luna EXP NX: {{:mdcpickandplace:lunaexpnxmanuale.pdf|}} |
+ | |||
+ | The manual for the software for the Luna EXP: {{:mdcpickandplace:lunaexpmanuale.pdf|}} | ||
+ | |||
+ | ===== Spec & Data sheets ===== | ||
The spec sheet for the MDC Luna EXP NX (stepper motors) {{:mdcpickandplace:lunaexpnxe.pdf|}} | The spec sheet for the MDC Luna EXP NX (stepper motors) {{:mdcpickandplace:lunaexpnxe.pdf|}} | ||
The spec sheet for the older MDC Luna EXP (servo motors) {{:mdcpickandplace:lunaexpbenche.pdf|}} | The spec sheet for the older MDC Luna EXP (servo motors) {{:mdcpickandplace:lunaexpbenche.pdf|}} | ||
+ | |||
+ | ===== Other docs ===== | ||
+ | |||
+ | Our MDC showed up with loose "homing dots" - the brackets on either side of the bank 1 feeders. As such the machine was not calibrated, and we needed to change the "Mark Calibration", here are detailed recalibration instructions: {{:mdcpickandplace:mdc_luna_mark_adjustment.pdf|}} | ||