This is an old revision of the document!
The manual for the software for the Luna EXP NX: lunaexpnxmanuale.pdf
The manual for the software for the Luna EXP: lunaexpmanuale.pdf
The spec sheet for the MDC Luna EXP NX (stepper motors) lunaexpnxe.pdf
The spec sheet for the older MDC Luna EXP (servo motors) lunaexpbenche.pdf
Our MDC showed up with loose "homing dots" - the brackets on either side of the bank 1 feeders. As such the machine was not calibrated, and we needed to change the "Mark Calibration", here are Isono's instructions: mdc_luna_mark_adjustment.pdf