tutorials:library:smt:framedstencils.html
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tutorials:library:smt:framedstencils.html [2011/05/02 22:32] daigo |
tutorials:library:smt:framedstencils.html [2016/01/28 18:05] (current) |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| - | If you want to make a lot of PCBs using SMT technique, its key to use reflowing instead of soldering - so that the entire board is 'soldered' at once. But to do that you'll need to deposit paste precisely on the pads. For starting out, you can use a [[http://www.ladyada.net/laserstencils.html|DIY stencil such as a laser cut kapton/mylar sheet (low cost)]] or depositing the paste by hand using a syringe. | + | If you want to make a lot of PCBs using SMT technique, its key to use reflowing instead of soldering - so that the entire board is 'soldered' at once. But to do that you'll need to deposit paste precisely on the pads. For starting out, you can use a [[http://www.ladyada.net/library/smt/laserstencils.html|DIY stencil such as a laser cut kapton/mylar sheet (low cost)]] or depositing the paste by hand using a syringe. |
/home/ladyada/public_html/wiki/data/attic/tutorials/library/smt/framedstencils.html.1304375528.txt.gz · Last modified: 2016/01/28 18:05 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
