This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
wavebubble:errata [2011/07/28 04:19] lcstyle [Battery board] |
wavebubble:errata [2016/01/28 18:05] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| Unfortunately, there are many errors or discrepancies between the various resources available for this project. Eventually, they will all be listed here; if you can then update one of the resources (schematic, PCB layout, assembly directions), please do so and then remove the error from this list. | Unfortunately, there are many errors or discrepancies between the various resources available for this project. Eventually, they will all be listed here; if you can then update one of the resources (schematic, PCB layout, assembly directions), please do so and then remove the error from this list. | ||
| + | Note: This errata does not apply to the WB 2010 design by Mictronics found here: http://ladyada.net/wiki/wavebubble/wave_bubble_2010 | ||
| ===== Part changes: ===== | ===== Part changes: ===== | ||
| ==== Battery board ==== | ==== Battery board ==== | ||
| ^ Part ^ Incorrect ^ Correct ^ Remarks ^ | ^ Part ^ Incorrect ^ Correct ^ Remarks ^ | ||
| | R2 | 2K, 0.25W | 500-1000 ohm | The lower the resistance, the brighter the power LED -- can be any wattage | | | R2 | 2K, 0.25W | 500-1000 ohm | The lower the resistance, the brighter the power LED -- can be any wattage | | ||
| + | | R3 | ? | do not place | unused | | ||
| + | | R4 | ? | do not place | unused | | ||
| + | | R5 | ? | do not place | unused | | ||
| + | | Q2 | ? | do not place | unused | | ||
| + | | D1 | ? | SS14 | | ||
| + | | J2 | optional | | If you omit this part, you have to jumper two pads together or else you won't get power from the USB port | | ||
| - | Mictronics Design WB 2010 Version is OK | ||
| ==== Main (radio) board ==== | ==== Main (radio) board ==== | ||