Ice Tube Clock - Setting the alarm

Introduction

If you'd like to use the clock as an alarm, you'll need to set the alarm time. Be sure to set the region first which will make it easier for you to set the alarm properly

Turning on/off the alarm

The alarm is turned on and off by the slide switch. If the alarm is set to ON you will see a dash on the left of the clock display indicating that.

For example, here is the clock display with the alarm on:

And this is the clock display with the alarm off:

Also, when you switch the alarm on you will see the display tell you the alarm is on and the alarm time:

When the alarm is ringing, you can turn it off by flipping the switch

Snoozing

When the alarm is ringing, you can go into 10-minute snooze by pressing any of the three buttons. The display will show the word Snoozing and then the time will be displayed but the dash will blink.

Every time you press a button, it will reset the snooze to 10 minutes

When the alarm is ringing, you can turn it off by flipping the switch

Setting the alarm - 12hr mode

Press the MENU button until Set aLar is displayed.

Now press the SET button to change the alarm

The current alarm is shown (8:15 PM).

For PM there will be a PM on the right hand side and a dot in the top left corner. The dots will indicate the hour

For AM there will be a AM on the right hand side and no dot in the top left corner.

Press the + button to change the hour. You can hold down + to quickly spin through the numbers.

Then press SET to set the hour and go on to set the minute. The dots will move to the minutes:

Press the + button to change the minutes. You can hold down + to quickly spin through the numbers.

Finally, press SET to finish setting the alarm

Setting the alarm - 24hr mode