Check to make sure your kit comes with the following parts.Sometimes we make mistakes so double check everything and email support@adafruit.com if you need replacements!

Image	Name	Description	Part #	Distributor	Qty
	IC1	Microcontroller (preprogrammed when purchased in a kit)	ATTINY85V-10-PU	Mouser Digikey (unprogrammed, of course)	1
	IC1'	8-pin socket	Generic	Mouser Digikey	1
	XTL1	8.00 MHz ceramic oscillator. It might also be blue.	ZTT-8.00MT or equivalient	Digikey Mouser	1
	C2	100uF/10V capacitor	Generic	Digikey Mouser	1
	C1	Ceramic 0.1uF capacitor (104)	Generic	Digikey Mouser	1
	R1-R4	47 ohm 1/4W 5% resistor (yellow violet black gold)	Generic		4
	R5	1.0Kohm 1/4W 5% resistor (brown black red gold)	Generic		1
	LED2, LED3	Narrow beam IR LED. These have a blue-ish tint.	Everlight IR333-A	Mouser	2
	LED1, LED4	Wide beam IR LED	Everlight IR333C/H0/L10	Mouser	2
	LED5	3mm LED	Generic	Digikey Mouser	1
	SW1	6mm tact switch button	Omron B3F-1000 (or equiv)	Digikey Mouser	1
	Q1 Q2 Q3 Q4	NPN Transistor (TO-92) that is pin compatible with 2N3904	PN2222		4
	JP2	10 pin box header		Mouser Digikey	1
	BATT	2 x AA battery holder	Generic	Digikey Mouser	1
	PCB	Circuit board		Adafruit Industries	1

If you have a black PCB with v1.1 on it

Note that the microcontroller must be programmed with the v1.1 firmware.
Any NPN transistor that is pin-compatible with the 3904 should be OK.
Use 940nm IR LEDs.

If you have a green PCB with v1.0 on it

Note that the microcontroller must be programmed with the firmware.
Any NPN transistor that is pin-compatible with the 3904 should be OK.
Use 940nm IR LEDs.