x0x:midisyncfabrication [AdaWiki]

- Midi, USB and Sync Section Fabrication
  - USB Section
  - Jacks and Connectors

Midi, USB and Sync Section Fabrication

USB Section

The USB section contains a surface mount chip. If you are at all unsure about soldering SMD parts, then you can get your x0xb0x built with the USB section built and tested for you for an extra 25 bucks. This is a good idea!

WorkOnMe: Someone else needs to write this section up

Jacks and Connectors

When soldering in the MIDI/DINSYNC connectors, make sure to ‘pre-stress’ them as they are a little flimsy. To do so press them back so that the face is flush with the PCB while soldering them in.

Be sure to use lots of solder on all of the connector components to make a good mechanical bond. The stresses of plugging and unplugging into the various I/O points may over time cause the solder joints to fail.

Navigation

Schematic	Power Supply	Voltage Controlled Oscillator	Voltage Controlled Filter	Envelope Generator	Voltage Controlled Amplifier	Headphone And Mixer	Digital Sequencer	Midi, USB and Sync
Fabrication	Building the Ps	Building the Vco	Building the Vcf	Building the Envelope	Building the Vca	Building the Headphone And Mixer	Building the Sequencer	Building the Midi and Sync	Finishing It Off
Testing	Testing the Ps	Testing the Vco	Testing the Vcf	Testing the Envelope	Testing the Vca	Testing the Headphone And Mixer	Testing the Sequencer	Testing the Midi and Sync
Mods	Ps Mods	Vco Mods	Vcf Mods	Envelope Mods	Vca Mods	Headphone And Mixer Mods	Sequencer Mods	Midi And Sync Mods	Finishing Mods