x0x:midisyncmods [AdaWiki]

- IO Board Mods
  - Change Midi Out to Another Midi Thru
  - Double Duty for the Jacks

IO Board Mods

Because of the relative simplicity of this section, there isn't much in the way of mods to be done here.

Change Midi Out to Another Midi Thru

VerifyMe: Someone competent with electronics needs to look over this to make sure it is correct.

Cut the trace to pin 5, and wire it up a 220 Ohm resistor to the Collector of Q50

Alternatively, this could be done in the FirmWare

Double Duty for the Jacks

The ring of Mix In and Mix Out are disconnected, and can be used as inputs (or outputs) for some of the VcoMods, VcfMods, EnvelopeMods or VcaMods.

The headphone out is split at the IO Board with the two resistors R164 and R186. You could disconnect one of them to also make it double as an input or an output.

Navigation

Schematic	Power Supply	Voltage Controlled Oscillator	Voltage Controlled Filter	Envelope Generator	Voltage Controlled Amplifier	Headphone And Mixer	Digital Sequencer	Midi, USB and Sync
Fabrication	Building the Ps	Building the Vco	Building the Vcf	Building the Envelope	Building the Vca	Building the Headphone And Mixer	Building the Sequencer	Building the Midi and Sync	Finishing It Off
Testing	Testing the Ps	Testing the Vco	Testing the Vcf	Testing the Envelope	Testing the Vca	Testing the Headphone And Mixer	Testing the Sequencer	Testing the Midi and Sync
Mods	Ps Mods	Vco Mods	Vcf Mods	Envelope Mods	Vca Mods	Headphone And Mixer Mods	Sequencer Mods	Midi And Sync Mods	Finishing Mods

CategoryMods