Parts
Check to make sure your kit comes with the following parts.Sometimes we make mistakes so double check everything and email support@adafruit.com if you need replacements!
| Image | Name |
Description | Part # | Distributor | Qty |
|||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
 |
IC1 |
Microcontroller (preprogrammed when purchased in a kit) | ATTINY2313-20PU |
|
1 |
|||||||
 |
IC2 |
Buffer chip (New in v2) |
74AHC125 | Mouser | 1 | |||||||
 |
XTL1 |
12.00 MHz ceramic oscillator Make sure it says 12.00 on it |
ZTT-12.00MT |
|
1 | |||||||
 |
C1 |
Bypass 0.1uF capacitor (104) Might be blue |
Generic | 1 |
||||||||
 |
C2 |
Bypass 100uF/6.3V electrolytic capacitor (photo shows 10V but 6.3V is fine) New in v2.0 |
Generic | 1 | ||||||||
|
R10 |
10K 1/4W 5% resistor (brown, black orange gold) | 10KQBK-ND | 1 | ||||||||
|
R3, R4, R5, R6, R7 |
1.5K 1/4W 5% resistor (brown green red gold) | 1.5KQBK-ND | 5 | ||||||||
|
R1, R2 |
27-68 ohm 1/4W 5% resistor | 47QBK-ND | 2 | ||||||||
 |
LED1 |
Red 3mm LED | Generic | 1 | ||||||||
 |
LED2 |
Green 3mm LED | Mouser Digikey |
1 | ||||||||
 |
D1, D2 |
3.6V Zener diode | 1N5227B | 2 |
||||||||
 |
X1 |
USB type B male jack | Generic | Mouser Digikey |
1 |
|||||||
 |
JP2 |
10 pin box header | Mouser Digikey |
1 |
||||||||
 |
JP1 |
6 pin straight header (0.1" x 0.1") | Molex 10-89-7062 | Mouser | 1 |
|||||||
 |
JP3 |
2 pin right angle header | Tyco 640453-2 | Mouser | 1 |
|||||||
 |
JP3' |
Jumper/Shunt | Generic | Mouser | 1 |
|||||||
 |
10 pin IDC cable | Generic Cable | 1 |
|||||||||
|
6 pin IDC cable | Generic Cable |
|
1 |
||||||||
 |
PCB |
Circuit board v2.0 looks different than v1.0 |
Adafruit Industries | 1 |
||||||||
 |
Case |
Enclosure | Pactec CNS-0407 | 1 |
Schematic (v2.0)
Click to enlarge...
